ABBERFIELD PACKET DISPENSING MACHINE -
model NPD600
OPERATIONS MANUAL # 059-1 page 6
The equipment is supplied ready to use, if operated from a standard power
point.
To access the mounting holes: -
1. Undo the screws to the top of the Inner Frame.
2. Lift out the inner frame, but take care as it is connected by cables to the
cabinet.
3. Unplug the three leads going to the Inner Frame circuit board.
4. Access is now made to the wall or bench mounting holes.
5. Use the frame as a template to mark the mounting holes. Then remove
and drill the wall or bench.
Note
: If the installation is in a
very
secure area, it may be sufficient to mount
the equipment to a wall by the top two bolt holes only. These can be
accessed without removing the Inner Frame.
If the double insulation of the mains wiring is in any way put at
risk, through alteration to the equipment, it is mandatory that the
cabinet is earthed. A screw for this purpose is positioned under
the Inner Frame.
Also under the inner frame is a terminal block for use in a permanently wired
application. If the fixed incoming mains wiring is through the existing cable
entry hole it may be acceptable to relocate the power supply elsewhere,
sitting loose under the inner frame. In this case the plastic cable clamp
provided may be useful to secure the mains wiring.
Take care when re-assembling the Inner Frame to tuck all wires into the free
space provided. Make sure none are caught under the Inner feet or on top of
the power supply, or this will lift the inner module and the packet being
dispensed may not line up with the fascia.
Remount the equipment taking care to ensure no masonry or dust or other
dirt is left behind.
INSTALLATION
32 Cross St, Brookvale, Sydney NSW 2100, Australia Tel: (02) 99392844 Fax: (02) 99383462 Email: [email protected]
