Do not instal within 10 feet of a pool, spa or fountain
CAUTION:
Fixture(s) must be installed in accordance with all local codes and ordinances.
INSTALLATION INSTRUCTION
To ensure optimal performance and safety, it is
important to use our fixtures ONLY with a low voltage
landscape transformer. This transformer reduces the
voltage from 120V to 12V, making it safe and suitable
for outdoor use.
When installing the fixture(s), please follow these
instructions carefully:
1.Before installation, please ensure that the power is
turned off for your safety.
2.Observe the upper portion of the fixture. To detach
the face plate, simply loosen the screws and proceed
to remove the gasket and glass from the housing.
3.Locate the socket where the lamp will be inserted.
Align the lamp's base or pins with the corresponding
slot in the socket. Gently push the lamp into the
socket, ensuring a secure and snug fit.
4.Carefully position the top part of the fixture above
the lower part. Carefully tighten the screws in a
clockwise direction until you feel the top part
properly engaging with the lower part until it is
securely fastened.
5. Select a suitable spot where you intend to dig the
hole, considering factors such as purpose,
accessibility, and any relevant guidelines or
regulations. Gradually dig deeper, removing the
loosened soil. Calculate the approximate volume of
pea gravel or sand required to fill the cleared space,
taking into account the 3-inch clearance on all sides.
Inspect the hole and surrounding area to ensure that
the depth, width, and clearance meet the specified
requirements.
www.ABBALightingUSA.com
By adhering to industry standards and best practices,
including proper wire stripping and secure fastening
techniques, a reliable connection can be established,
ensuring optimal performance, safety, and longevity
of the system.
7.To install the fixture in the hole and ensure proper
water drainage by filling the extra space with pea
gravel or sand, please follow these instructions:
Step 1
: Prepare the fixture for installation:
a. Make sure the fixture is clean and free from any
debris or obstructions.
b. Ensure that any necessary electrical connections
have been made or are ready to be connected.
Step 2
: Position the fixture in the hole:
a. Carefully lower the fixture into the hole, aligning it
with the opening and ensuring it sits securely.
b. Adjust the position of the fixture as needed to
ensure proper orientation and alignment with any
mounting or connection points.
Step 3
: Fill the extra space with pea gravel or sand:
a. Take the pea gravel or sand that you have prepared
for filling the extra space.
b. Begin pouring or distributing the pea gravel or
sand around the sides of the fixture, allowing it to fill
the space between the fixture and the hole.
c. Use a shovel or similar tool to gently pack the pea
gravel or sand, ensuring it settles evenly and
provides stable support.
Step 4
: Verify the completed installation:
a. Inspect the fixture to confirm that it is securely
positioned in the hole.
6. To establish a dependable and enduring electrical
connection between fixture wires and the main line in
outdoor or underground installations, it is essential to
select a suitable main cable connector designed for
direct burial. This connector should be chosen based
on its ability to withstand environmental conditions,
resist moisture and corrosion, and provide robust
insulation.
