Planning and Installation Guidelines 25
Planning and
Installation Guidelines
Technical Description
Wireless Proximity Switches / Issue: 09.2004
V 6
WINK Mode
For the clear allocation of the sensor number indicated in the display to one in the field installed
wireless proximity switch the WINK-mode exists.
As long as a sensor without disturbance is displayed, this sensor can be triggered by pressing
OK
so that its green LED blinks. At the same time the sensor number in the display of the input
module blinks.
The WINK-mode ends automatically after 60 seconds or as soon as it is started for another
proximity switch. Likewise the WINK-mode can be triggered by pressing of the membrane switch
on a wireless proximity switch.
3.5 Password inquiry
If a password (001... 999) had been assigned to the input module, then this is queried after each
change out of the RUN-mode, before the first change of the settings of the input module can be
done. After 30 seconds without input, the password inquiry will be left automatically.
RUN
017 1 12
RUN
017 1 12
Procedure
Press
membrane switch
at communication
module
Communication module (Top view)
Display content *)
OK
PASSWORD CHECK
000
Procedure
Description
Display content *)
Operator
options
Password Enquiry
Input
Increase or decrease of the selected number (blinkt)
leave the password inquiry
change to the next number;
Confirmation of password after the last number
/\
or
\/
ESC
OK
After successful password entry, the module releases the desired menu.
If a wrong number is entered, the password inquiry is repeated.
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display