ABB Welcome, User Manual

Page: 34 / 58

Installation of the outdoor stations
Fig. 22 Fig. 23
For all outdoor stations an installation wall box of matching
colour is available for flush-mounting or surface-mounting.
Surface-mounting is suitable for all types of walls, whether
rendered, clinker or cavity wall. They are recommended
particularly for walls with a thermal sandwich system. Here
the use of suitable mounting material should be ensured.
Also flush-mounting is possible on the same wall types,
because the installation socket has a full perimeter frame.
For flush-mounting in a cavity wall (thickness between 2 and
25 mm) a cavity wall mounting set consisting of mounting
anchors is available.
To make plastering easy after a cavity has been cut into of
the wall for flush-mounted installation a mounting accessory
is available. This is inserted in the cavity and removed again
after plastering is completed. The flush-mounting box can
then be installed.
For dismantling the end strip, a distance of 1 cm should be
kept to the right of the outdoor station.
To be able to change the name plates while the outdoor
station is mounted, a distance of 10 cm should remain free
below the outdoor station. If this is not possible the outdoor
station must be removed from the installation socket to
change the name plates.
Note: The camera of the ABB-Welcome video outdoor station
should not face powerful light sources, such as street lights.
This should be taken into consideration when choosing the
correct position for mounting. Lamps in the entrance area
should uniformly illuminate the face of the visitor. The
recommended installation height is 1.50 m. This optimally
captures persons of average body size. Bright or backgrounds
with a deep contrast should be avoided. It could reduce the
quality of the picture.
Installation of indoor stations
The ABB-Welcome audio indoor station with handset and
the ABB-WelcomeTouch are easy to install as a surface-
mounted device with the aid of the enclosed mounting frame.
The devices can also be mounted on a commercially available
58 flush-mounted wall box.
The ABB-Welcome audio indoor station with display can be
installed in the design of various switch programs and so
adapts to the other light switches and socket outlets in an
apartment. Two 58 flush-mounted wall boxes are required for
the installation.
Additional information is contained in the operating manuals.
The associated QR codes are listed starting from page 46.
Fig. 23 Fig. 22
Detection angle of camera The distance zones for the installation of the
outdoor station
1 cm
10 cm
Distance zone
1.5 m
0.6 m
1.90 m 1.10 m 1.70 m 0.82 m
0.6 m
2.18 m 1.30 m
0.6 m
0.6 m
0.4 m
0.4 m
1.12 m
+
–15°
-15° +15°
34 Installation |
User Manual ABB-
Wel
come