14 OI/TTH300-EN Rev. D |
TTH300
6
Transport and storage
6.1
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
6.2
Transporting the device
Observe the following instructions:
— Do not expose the device to moisture during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
6.3
Storing the device
Bear the following points in mind when storing devices:
— Store the device in its original packaging in a dry and
dust-free location.
— Observe the permitted ambient conditions for transport
and storage.
— Avoid storing the device in direct sunlight.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
6.3.1
Ambient conditions
The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!
6.4
Returning devices
For the return of devices, follow the instructions in the chapter
"Repair" on page 40.
7
Installation
7.1
Installation options
There are three options for installing the transmitter:
— Installation in the cover of the connection head (without
springs)
— Direct installation on the measuring inset (with springs)
— Installation on a top-hat rail
7.1.1
Installation in the cover of the connection head
Fig. 11
1. Release the screw plug
3
for the cover of the connection
head
2. Open
the
1
cover.
3. Secure
2
the transmitter 2 at the proper position on the
cover, using the captive screws found in the transmitter.
1
2
3
A10067
