SCR E E N M A STE R S M10 0 0, S M 20 0 0 A N D S M3 0 0 0
| R EP L AC I N G T H E B AT T ER Y | I N F0 5/9 0 R E V. E
3
4
Remove the main board – see Figure 3.
Note.
Refitting is the reverse of removal.
Lift each end of the connection locking bar
carefully and disconnect the display flex-circuit
from the main board – see
Note 1
SM2000 only – disconnect the touchscreen
from the main board – see
Note 2
Slot D – see
Note 1
See
Caution
SM1000 only – disconnect the membrane switch
connector from the main board
SM1000 only – disconnect the
inverter connector from the
main board
Withdraw the main board
from the chassis
Connection locking bar
1
2
2
3
4
4
Notes.
1. To disconnect the display flex-circuit, it may be necessary to remove the I/O module board in Slot D (if fitted).
2. SM2000 main boards manufactured before March 2005 have a 4-pin tochscreen flexi-circuit and a 4-pin connector block. Main boards
manufactured from March 2005 onwards are fitted with a 6-pin connector block. When reconnecting the touchscreen flex-circuit to a
main board equipped with a 6-pin connector block, ensure it is connected to the
4 pins nearest the front of the recorder.
Caution. When fitting a main board, ensure it
locates correctly in the lugs on the chassis
base.
Figure 3 Removing the main board