S M10 0 0, S M 20 0 0 A N D S M3 0 0 0
| I/O M O D U L E B OA R D I N S TA L L AT I O N | I N F01 /49 R E V. E
7
4 Referring to Figure 7 on page 5, loosen the 3 screws
securing the terminal cover and remove the cover (if fitted).
5 Referring to Figure 9, remove the recorder case blanking
plate (if fitted) and fit the 20-way connector.
Note.
Refer to the User Guide (
) for connection details
for all I/O module boards.
6 Referring to Figure 7 on page 5, refit the terminal cover
(if fitted) and refit the recorder to its case.
7 Restore the power supply to the recorder.
1
Remove self-adhesive
blanking plate from
appropriate slot
ininstrument case
Affix the
appropriate label
to the 20-way
connector
2
A
C
4
…and insert20-way
connector into
appropriate slot
B
H
G
F
E
D
Ensure PCB guides are fitted correctly…
3
Note.
To remove a 20-way connector, depress the tabs at each end using a small,
flat-bladed screwdriver and withdraw.
Note.
The 20-way connector included in analog input module
board pack GR2000/0708 has a thermistor and cover fitted.
This connector is used with standard analog input module
boards only, which must be fitted in positions A or B only.
Note.
The 20-way connector included in high-
specification analog input module board pack
GR2000/0714 has a thermometer and cover fitted,
and can be identified by having 2 black, blanking
plugs in terminal screw positions 10 and 11. This
connector must be used with high-specification
analog input module boards only, which must be
fitted in positions A or B only.
Figure 9 Fitting the 20-way connector
