For example, the function can be enabled and disabled with the
Operation
setting.
•
Each function block symbol shows the available input/output signal.
•
the character ^ in front of an input/output signal name indicates that the signal name may
be customized using the PCM600 software.
•
the character * after an input signal name indicates that the signal must be connected to
another function block in the application configuration to achieve a valid application
configuration.
•
Dimensions are provided both in inches and millimeters. If it is not specifically mentioned then
the dimension is in millimeters.
1.5
IEC 61850 edition 1 / edition 2 mapping
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v9
Function block names are used in
ACT
and
PST
to identify functions. Respective function block
names of Edition 1 logical nodes and Edition 2 logical nodes are shown in the table below.
Table 1:
IEC 61850 edition 1 / edition 2 mapping
Function block name
Edition 1 logical nodes
Edition 2 logical nodes
-
-
ALGOS
AGSAL
AGSAL
SECLLN0
AGSAL
ALMCALH
ALMCALH
ALMCALH
ALTIM
-
ALTIM
ALTMS
-
ALTMS
ALTRK
-
ALTRK
BTIGAPC
B16IFCVI
BTIGAPC
DPGAPC
DPGGIO
DPGAPC
DRPRDRE
DRPRDRE
DRPRDRE
INDCALH
INDCALH
INDCALH
ITBGAPC
IB16FCVB
ITBGAPC
L4UFCNT
L4UFCNT
L4UFCNT
LD0LLN0
LLN0
-
LPHD
LPHD
MVGAPC
MVGGIO
MVGAPC
QCBAY
QCBAY
BAY/LLN0
RCHLCCH
RCHLCCH
RCHLCCH
SCHLCCH
SCHLCCH
SCHLCCH
SCSWI
SCSWI
SCSWI
SLGAPC
SLGGIO
SLGAPC
SMPPTRC
SMPPTRC
SMPPTRC
SP16GAPC
SP16GGIO
SP16GAPC
SPC8GAPC
SPC8GGIO
SPC8GAPC
SPGAPC
SPGGIO
SPGAPC
SSCBR
SSCBR
SSCBR
SSIMG
SSIMG
SSIMG
SSIML
SSIML
SSIML
Table continues on next page
Section 1
1MRK 511 441-UEN Rev. C
Introduction
6
Switchgear control unit SAM600-IO
Communication protocol manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved
