ABB REG316 4 Series, Operating Instructions Manual

Page: 594 / 980

ABB Switzerland Ltd REG 316*4 1MRB520049-Uen / Rev. C
6-10
The table below explains the significance of the various items of
information.
Neuron Chip ID-No. Hardware number of the neuron chip on the PC card
LON interface ID Must always be set to “DP_MIP”.
Domain Number of the domain to which the device belongs
(can be set via the LON bus).
Subnet No. Number of the sub-network to which the device
belongs (can be set via the LON bus).
Node No. Device node number (can be set via the LON bus).
Transmission errors Number of errors detected during reception.
Transaction timeouts Number of transaction confirmations not received.
Receiver transaction
timeouts Number of messages received that were lost,
because of incorrect settings at the receiving end.
Lost messages Number of messages lost, because the receive
memory in the RE.316*4 was full.
Missed messages Number of messages lost, because the receive
memory on the PC card was full.
Reset cause Reason for the last restart executed by the PC card.
Interface Status Normal: “Configured and on-line”.
Version number PC card firmware version
Error number 0 = no error or error on the PC card.
Model number Always 0
Driver state OK or error message
Cross table for
network variables Valid or invalid (table loaded via the LON bus).
No. of semaphore hits Information for ABB purposes
No. of semaphore
misses Information for ABB purposes
No. of semaphore
fails Information for ABB purposes
No. of IN buffer
overflows Number of messages lost, because the driver buffer
was full.
No. of transmitted
messages Total number of messages transmitted since the
information was deleted.
No. of received
messages Total number of messages received since the
information was deleted.