6
1MRK 500 080-UEN rev. -
Configuring the IED 670 functions
Start-up
The PCM 600 toolbox is used to configure protection IEDs in the IED 670
series. The tool includes a project manager and tools for all necessary tasks.
Install the PCM 600 in your computer first and then install the IED connectivity
packages. Start the PCM 600 and build a new project.
System requirements:
•
Operating system: Windows 2000 SP4 / XP SP2
Hardware requirements, minimum/recommended:
•
Physical RAM memory: 512 MB / 1 GB
•
Free hard disk space: 500 MB / 1 GB
•
Processor: Pentium 900 MHz / Pentium 2 GHz
To start installation of PCM 600 insert the installation CD into the CD-drive. If
installation doesn’t start automatically, execute setup.exe in the root folder on
the installation CD. When the installation begins select the software that you
prefer to install and follow the instructions to complete the installation.
Note! If you don’t have Microsoft SQL Server Desktop Engine already installed
this will be installed when installing PCM 600. Installation of PCM 600 can
only be made as a standalone installation.
After the installation has completed, start Connectivity Package Manager from
desktop to activate installed Connectivity Packages for PCM 600.
Prerequisites:
•
To operate with PCM 600, there must be at least one communication Con-
nectivity Package and one IED Connectivity Package installed and selected
to be used with PCM 600. The IED Connectivity Packages are delivered with
the IED’s.
Start the PCM 600 from the desktop and build a new project. For the new
project your system structure with stations, voltage levels, bays and IEDs is
built-up in the plant structure. Right click your mouse or locate the plant struc-
ture components in the menu.
Setting up your communication
To communicate with the IED the following set-up is required under the com-
munication structure and/or properties for an IED.
•
The TCP/IP address on the PC must be set. If your computer setting is DHCP the
connection will not work. Set-up your PC manually with values close to the values
set in the HMI tree, under General settings/Communication/Network Interface/
Ethernet. Note! You need to have administrator rights to start up the communica-
tion.
•
The IP address is set under communication structure (right click the plant structure
tab) Select the IED and set the IP address under properties as shown in figure 6.
•
Set the SPA address for the IED under the communication structure. Open the IED
and the LDO and set the address to 30. See figure 8.
Figure 6: Setting IP.
Figure 7: OPC Server configuration.
Figure 8: SPA Address.
