ABB FSO-12, User Manual

Page: 291 / 388

Parameters 291
FSOGEN.42 Acknowledgement
button input
Sets the digital input that is connected to the
button for acknowledgement operations. None
None No input connected
DI X113:1 Single input X113:1
DI X113:2 Single input X113:2
DI X113:3 Single input X113:3
DI X113:4 Single input X113:4
DI X114:1 Single input X114:1
DI X114:2 Single input X114:2
DI X114:3 Single input X114:3
DI X114:4 Single input X114:4
FSOGEN.51 Zero speed without
encoder
Sets the general zero speed limit for safety
functions when an encoder is not used. In
this case, the motor speed is an estimate.
Select a suitable value depending on your
motor.
Note : This is the absolute value. The same
value is used in both positive and negative
directions.
Note : You cannot set trip limits below this
value.
0.0 rpm
0.0…600.0 rpm Speed
FSOGEN.61 STO indication ext
request
Sets the type of the event that the FSO
module generates and sends to the drive
after external requests that end to a
successful activation of the drive STO
function (STO, SSE or SS1).
Note: When the FSO module triggers the
STO function in fault situations, it always
generates a fault.
Fault
None No event generated
Fault Fault generated
Warning Warning generated
Event Pure event generated
FSOGEN.62 STO indication
safety limit
Sets the type of the event that the FSO
module generates for limit hits in the SLS1,
…, SLS4 and SMS functions and for limit
hits during ramp and time monitoring of
safety ramps SAR0 and SAR1.
Note: When the FSO module triggers the
STO function in fault situations, it always
generates a fault.
Fault
None No event generated
Fault Fault generated
Index Name/Value Description Factory
default