Charging process
Operating instructions V 1.00 Document: V 1.00 / Document No.: 105728
│
Date 28.05.2018
│
19
6
Charging process
6.1
Starting the charging process
The starting of a charging process depends on whether the charging station has authorization.
This is visible on the LED bar:
■
Flashing green: No authorization required
■
Flashing blue: Authorization required
Information
If the charging station is authorized without a vehicle plugged in, a vehicle can
be plugged in for 60 seconds and this will start a charging session.
Ladevorgang starten
To start, proceed as follows:
1. Plug the charging cable into the vehicle.
2. For charging station with charging socket: Plug the charging cable into the charging socket
of the charging station.
3. At charging station with authorization: Authorization at the charging sta- tion by holding an
RFID card or plugging in and turning the key to the right. The key can then be removed. Der
Ladevorgang kann nun durch das Fahrzeug gestartet werden.
The charging process can now be started by the vehicle.
If an interruption occurs during the plugging-in or charging procedure, the charging station will
attempt to automatically restart the charging procedure (max. 5 times). If the charging process
is still not able to be started after max. 5 attempts, the charging station goes into an error state.
This can be remedied by properly terminating the charging process and possibly restart- ing the
charging station. If the error occurs repeatedly, please contact your service partner.
6.2
Ending the charging process
To properly end the charging procedure, proceed as follows:
1. End the charging process on the vehicle
2. For charging station with charging socket: Disconnect the charging cable at the charging
station
3. For charging stations with permanently installed charging cable: Stowing of the charging
cable on the holder of the charging station
The charging process is completed.
Summary of Contents for EVLunic
Page 2: ......
