ABB COMMANDER 1900 Series, User Manual

Page: 12 / 36

10
…2 CONTROL CONFIGURATION LEVEL
…2.3 Ramp/Soak Profile Program
Table 2.1 Description of Sources
Source Description
EQN – 8
EQN – 1
Logic equation 8
Logic equation 1
dIG – 6.8
dIG – 1.1
Digital Input 6.8
Digital input 1.1
AL – d4
AL – C4
AL – b4
AL – A4
Alarm D
Alarm C
Alarm B
Alarm A
AL – d3
AL – C3
AL – b3
AL – A3
AL – d2
AL – C2
AL – b2
AL – A2
AL – d1
AL – C1
AL – b1
AL – A1
NONE
No source required
Alarm D
Alarm C
Alarm B
Alarm A
Alarm D
Alarm C
Alarm B
Alarm A
Alarm D
Alarm C
Alarm B
Alarm A
Programmable logic equations – refer to the
Set Up Logic
Section in the
Programming Guide
Digital Input number
Module number
Channel 4 Alarms (if applicable)
Channel 3 Alarms (if applicable)
Channel 2 Alarms (if applicable)
Channel 1 Alarms
tIMEr.2
tIMEr.1
Real time events (only available if timer option fitted)
Real time event 2
Real time event 1
rAP – 4
* COUNt. 4
rAP – 1
*
COUNt. 1
Wrap-around on total 4
Total 4 external counter drive
Wrap-around on total 1
Total 1 external counter drive
Wrap-around and count (only available if totalizer option fitted)
MAN–x
AUtO–x
Control mode selected for controller 1 or 2
Manual control
Automatic control
2Nd–x
LOC–x
Set point selected for controller 1 or 2
Second set point
Local set point
OnOFFx
OP–x
OP–xc
OP–xh
Only available on relay and
digital outputs
Control output 1 or 2 on/off
Control output 1 or 2 (time proportioning)
Control output cool 1 or 2 (time proportioning)
Control output heat 1 or 2 (time proportioning)
OPEN–x
CLSE–x
Motorized valve control for controller 1 or 2
(only available on relay and digital outputs)
Motorized valve 1 or 2 open
Motorized valve 1 or 2 closed
SEG–99
SEG–0
PG-2.10
PG-1.01
ENd–x
HbK–x
rUN–x
HOLd–x
Profile segment 99
Profile segment 0
Profile program 10, Controller 2
Profile program 1, Controller 1
Program end (duration 1 second)
Program in hold due to holdback hysteresis
Profile 1 or 2 running
Profile 1 or 2 in hold mode
Profile (ramp/soak) control for controller 1 or 2
ACFAIL Power Failure
*Only available on relays and digital outputs on module types 3 and 5.
• Ramp/Soak