3 Installation
Endura AZ20 oxygen monitor | Pumped reference air unit |
INF09/027 Rev. D
5
3.4 Accessing the terminal block
Referring to Fig. 3.3:
1. Loosen the 4 pump cover retaining screws
A
.
2. Remove the pump cover
B
.
3. Loosen cable gland
C
to prepare for the incoming power
supply cable.
3.5 Electrical connections
3.5.1 Preparation
Referring to Fig. 3.4:
1. Prepare the incoming power supply cable as follows:
a. cut the outer sheath back to leave 100 mm (4.0 in.)
sleeved wires
A
b. cut the sleeved wires back to leave 5 mm (0.2 in.) tails
B
2. Pass the cable through cable gland
C
.
Fig. 3.3 Accessing the Terminal Block
B
C
A
Pump Identification
Label
