ABB ACS880-x04, Firmware Manual

Page: 101 / 604

Application macros 101

Default control connections for the Hand/Auto macro
Fault
XPOW External power input
1 +24VI
24 V DC, 2 A
2 GND
XAI Reference voltage and analog inputs
1 +VREF 10 V DC, R
L
1…10 kohm
2 -VREF -10 V DC, R
L
1…10 kohm
3 AGND Ground
4 AI1+ Speed reference (Hand)
0(2)…10 V, R
in
> 200 kohm
5 AI1-
6 AI2+ Speed reference (Auto)
0(4)…20 mA, R
in
= 100 ohm
7 AI2-
XAO Analog outputs
1 AO1 Motor speed rpm
0…20 mA, R
L
< 500 ohm
2 AGND
3 AO2 Motor current
0…20 mA, R
L
< 500 ohm
4 AGND
XD2D Drive-to-drive link
1 B
Master/follower, drive-to-drive or embedded fieldbus
interface connection
2 A
3 BGND
XRO1, XRO2, XRO3 Relay outputs
1 NC Ready run
250 V AC / 30 V DC
2 A
2 COM
3 NO
1 NC Running
250 V AC / 30 V DC
2 A
2 COM
3 NO
1 NC Fault (-1)
250 V AC / 30 V DC
2 A
2 COM
3 NO
XD24 Digital interlock
1 DIIL Run enable
2 +24VD +24 V DC 200 mA
3 DICOM Digital input ground
4 +24VD +24 V DC 200 mA
5 DIOGND Digital input/output ground
XDIO Digital input/outputs
1 DIO1 Output : Ready run
2 DIO2 Output : Running
XDI Digital inputs
1 DI1 Stop (0) / Start (1) – Hand
2 DI2 Forward (0) / Reverse (1) – Hand
3 DI3 Hand (0) / Auto (1)
4 DI4 Constant speed 1 (1 = On)
5 DI5 Forward (0) / Reverse (1) – Auto
6 DI6 Stop (0) / Start (1) – Auto
XSTO
Safe torque off circuits must be closed for the drive to start. See
Hardware manual of drive.
X12 Safety options connection
X13 Control panel connection
X205 Memory unit connection