ABB ACS880 N5700 Series, Firmware Manual, Page: 355 / 662

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
Peak value and amplitude logger settings. Load analyzer 36
See also section Load analyzer (page 119) .
Power inu out /
uint32 Selects the signal to be monitored by the peak value
logger.
The signal is filtered using the filtering time specified
by parameter
36.2 PVL filter time .
PVL signal source 36.1
The peak value is stored, along with other pre-selected
signals at the time, into parameters
36.12 … 36.15 .
The peak value logger can be reset using parameter
36.9 Reset loggers . The logger is also reset whenever
the signal source is changed. The date and time of the
last reset are stored into parameters
36.16 and 36.17
respectively.
0 None Zero
1 1.1 Motor speed used (page 134) . Motor speed used
3 1.6 Output frequency (page 134) . Output frequency
4 1.7 Motor current (page 134) . Motor current
6 1.10 Motor torque (page 134) . Motor torque
7 1.11 DC voltage (page 135) . DC voltage
8 1.14 Output power (page 135) . Power inu out
10 23.1 Speed ref ramp input (page 270) . Speed ref ramp in
11 23.2 Speed ref ramp output (page 270) . Speed ref ramp out
12 24.1 Used speed reference (page 277) . Speed ref used
13 26.2 Torque reference used (page 297) . Torq ref used
See Terms and abbreviations (page 130) . Other [value]
2.00 s / real32 Defines a filtering time for the peak value logger. See
parameter
36.1 PVL signal source .
PVL filter time 36.2
100 = 1 s / 100 = 1 s Peak value logger filtering time. 0.00 ... 120.00 s
Ambient temperature
/ uint32 Selects the signal to be monitored by amplitude logger
2. The signal is sampled at 200 ms intervals, and can
be scaled using parameter
36.7 AL2 signal scaling .
AL2 signal source 36.6
The results are displayed by parameters 36.40 … 36.49 .
Each parameter represents an amplitude range, and
shows what portion of the samples fall within that
range.
Amplitude logger 2 can be reset using parameter
36.9
Reset loggers . The logger is also reset whenever the
signal source or scaling is changed. The date and time
of the last reset are stored into parameters
36.50 and
36.51 respectively.
0 None Zero
1 1.1 Motor speed used (page 134) . Motor speed used
3 1.6 Output frequency (page 134) . Output frequency
4 1.7 Motor current (page 134) . Motor current
6 1.10 Motor torque (page 134) . Motor torque
Parameters 355