ABB ACS880 ESP, Firmware Manual

Page: 397 / 494

Additional parameter data 397
78 Pump underload protection
78.01 Underload limit display List - - 1 = 1
78.02 Underload function Binary
src
- - 1 = 1
78.03 Torque1 Real 0.00...10000.00 T(%) or
A(%)
100 = 1 T(%)
or A(%)
78.04 Speed1 Real -3600.00...3600.00 Prpm, rpm
or Hz
100 = 1 Prpm,
rpm or Hz
78.05 Torque2 Real 0.00...10000.00 T(%) or
A(%)
100 = 1 T(%)
or A(%)
78.06 Speed2 Real -3600.00...3600.00 rpm or Hz 100 = 1 Prpm,
rpm, Hz
78.07 Torque3 Real 0.00...10000.00 T(%) or
A(%)
100 = 1 T(%)
or A(%)
78.08 Speed3 Real -3600.00...3600.00 Prpm, rpm
or Hz
100 = 1 Prpm,
rpm or Hz
78.09 Underload delay time Real 0.000...100000.000 s 1000 = 1 s
79 Pump temperature protection
79.01 Temperature protection
function Binary
src
- - 1 = 1
79.02 Temperature protection device List 0...2 - 1 = 1
79.03 Klixon signal source Binary
src
- - 1 = 1
79.04 PT100 source Analog
src
- F,C 1 = 1
79.05 PT100 exitation source Analog
src
- mA 1 = 1
79.06 PT100 internal selection List 0.00...20.00 mA 100 = 1 mA
79.07 Number of PT100 sensors in
series List 1...3 - 1 = 1
79.08 Warning temperature limit Real 0.00...200.00 °C or °F 100 = 1 °
79.09 Fault temperature limit Real 0.00...200.00 °C or °F 100 = 1 °
80 Pump backspin control
80.01 Backspin enable Binary
src
- - 1 = 1
80.02 Backspin ref limit Real -500.00...0.00 Prpm 1 = 1
80.03 Backspin acc time Real 0.000...10000.000 s 1 = 1
80.04 Backspin stop torque Real 0.00...10000.00 Nm 1 = 1
80.05 Backspin speed range trim Real 0.00...100.00 % 1 = 1
80.11 Start delay enable Binary
src
- - 1 = 1 mA
80.12 Start delay time Real 0 … 4294967.295 s 1000 = 1 s
90 Feedback selection
90.01 Motor speed for control Real -32768.00…32767.00 rpm 100 = 1 rpm
90.02 Motor position Real 0.00000000…1.00000000 rev 100000000 =
1 rev
No. Name Type Range Unit FbEq32