Start up and use 3
2
Start up and use
Start up
To start up the drive, you need to set the motor data, motor control, connection macro
and drive parameters. See the relevant drive firmware manual for start-up details.
Control panel use
1. Clip - press down to remove the panel.
2. Display - shows the selected settings and
menus.
3. RJ-45 connector slot on the back of the panel.
4. Back button - move back in menus, open the
Options menu.
5. OK button - select settings, open the Main
menu.
6. Status leds - green and red colors indicate the
state of the drive and potential problems.
7. Arrow buttons - move in the menus.
8. Start and Stop buttons - start and stop the
operation in local control mode.
9. Loc/Rem button - switch between local and
remote control modes.