ABB ACS 800 Series, Firmware Manual

Page: 62 / 340

Program features
62
Programmable digital inputs
The drive has seven programmable digital inputs as a standard. Nine extra inputs
are available if optional digital I/O extension modules are used.
Update cycles in the Crane control program
Settings
Diagnostics
Input Cycle
DI / standard 6 ms
DI / extension 20 ms
Parameter Additional information
Group 10 START/STOP/
DIR
DI as start, stop, direction
Group 11 REFERENCE
SELECT
DI in reference selection, or reference source
Group 12 STEP
REFERENCING
DI in step reference selection
Group 16 SYST CTRL
INPUTS
DI as external Run Enable, fault reset or user macro change signal
22.01 DI as acceleration and deceleration ramp selection signal
30.03 DI as external fault source
30.05 DI in motor overtemperature supervision function
30.22 Supervision of optional I/O use
42.02 DI as mechanical Brake Acknowledge signal
98.03 … 96.05 Activation of the optional digital I/O extension modules
Actual signal Additional information
01.17 Status of the standard digital inputs.
Example: 0000001 = DI1 is on, DI2 to DI6 and DIL are off.
Bit
Value
Input 6
0
DIL 5
0
DI6 4
0
DI5 3
0
DI4 2
0
DI3 1
0
DI2 0
1
DI1
01.40 Values of the optional digital inputs
Warning
IO CONFIG Improper use of optional I/O
Fault
I/O COMM ERR Communication loss to I/O