ABB ACS 800 Series, Application Manual

Page: 36 / 44

Actual signals and parameters in ACS800 Standard Application Program
36
83.03 EDIT BLOCK Defines the block location number for the command selected by parameter
83.02 .
1 … 15 Block location number.
83.04 TIMELEVEL SEL Selects the execution cycle time for the Adaptive Program. The setting is
valid for all blocks.
12 ms 12 milliseconds
100 ms 100 milliseconds
1000 ms 1000 milliseconds
84 ADAPTIVE PROGRAM Creation and diagnostics of the Adaptive Program.
84.01 STATUS Shows the value of the Adaptive Program status word. The table below
shows the alternative bit states and the corresponding values on the panel
display.
84.02 FAULTED PAR Points out the faulted parameter in the Adaptive Program.
84.05 BLOCK1 Selects the function block for Block Parameter Set 1.
ABS See the chapter Function blocks.
ADD See the chapter Function blocks.
AND See the chapter Function blocks.
COMPARE See the chapter Function blocks.
EVENT See the chapter Function blocks.
FILTER See the chapter Function blocks.
MAX See the chapter Function blocks.
MIN See the chapter Function blocks.
MULDIV See the chapter Function blocks.
NO See the chapter Function blocks.
OR See the chapter Function blocks.
PI See the chapter Function blocks.
PI-BAL See the chapter Function blocks.
SR See the chapter Function blocks.
SWITCH-B See the chapter Function blocks.
SWITCH-I See the chapter Function blocks.
TOFF See the chapter Function blocks.
TON See the chapter Function blocks.
TRIGG See the chapter Function blocks.
XOR See the chapter Function blocks.
Index Parameter name /
value
Description FbEq
Bit Display Meaning
0 1 Stopped
1 2 Running
2 4 Faulted
3 8 Editing
4 10 Checking
5 20 Pushing
6 40 Popping
8 100 Initialising