ABB ACQ810, Firmware Manual

Page: 280 / 376

280 Parameters
82.11 Supervis delay Delay for signal triggering of the cleaning sequence. See
parameter
82.09 Supervis source .
0…600 s Cleaning sequence triggering delay. 1 = 1 s
82.12 Trig pointer Cleaning sequence trigger input selection. See parameter
82.01 Pump clean trig , bit 6.
Not used No input selected. 0
DI1 Digital input DI1 (as indicated by 02.01 DI status , bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status , bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status , bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status , bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status , bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109 ).
-
Pointer
82.13 Clean max ctrl Defines the action taken if the maximum number of cleaning
sequences (
82.14 Clean max number ) is exceeded within
the time set by parameter 82.15 Clean max period . Forced
cleanings are disregarded.
Not sel No action taken. 0
Alarm The drive generates an alarm, MAX CLEANINGS . 1
Fault The drive trips on fault MAX CLEANINGS . 2
82.14 Clean max number Defines the maximum number of cleaning sequences within
the time set by parameter
82.15 Clean max period .
0…30 Maximum number of cleaning sequences. 1 = 1
82.15 Clean max period Defines the time (ending now) within which cleaning
sequences are counted.
0.00 … 35791394.11
h Time within which cleaning sequences are counted. 100 = 1 h
82.16 Clean step acc Defines the acceleration time from 0 rpm to the step
frequency (parameters
82.02 Fwd step and 82.03 Rev step ).
0…32767 s Step acceleration time. 1 = 1 s
82.17 Clean step dec Defines the deceleration time from the step frequency
(parameters
82.02 Fwd step and 82.03 Rev step ) to 0 rpm.
0…32767 s Step deceleration time. 1 = 1 s
83
83 Energy monitoring
Energy consumption monitoring settings.
See also section
Energy consumption monitoring on page
81 .
83.01 Energy mon mode Enables/disables, and selects the mode of, consumed
energy monitoring.
Not used Energy monitoring not in use. 0
Limits The current energy monitoring period is compared to the
consumption limit set by parameter
83.03 kWh limit .
1
Previous The current energy monitoring period (parameter 05.20 kWh
current read ) is compared to the previous period ( 05.21 kWh
prev read ).
2
No. Name/Value Description FbEq