ABB ACQ580-07, Hardware Manual

Page: 87 / 324

The abbreviations used in the tables are defined below.
Definition Abbr.
Nominal AC line voltage U
n
Peak line-to-line voltage at motor terminals which the motor insulation must
withstand Û
LL
Motor nominal power P
n
d u /d t filter at the output of the drive d u /d t
Common mode filter CMF
N-end bearing: insulated motor non-drive end bearing N
Motors of this power range are not available as standard units. Consult the
motor manufacturer. n.a.
Availability of du/dt filter and common mode filter by drive type
Availability of common mode
filter (CMF) Availability of du/dt filter Product type
+E208 +E205 ACQ580-07
Additional requirements for explosion-safe (EX) motors
If you will use an explosion-safe (EX) motor, follow the rules in the requirements table
above. In addition, consult the motor manufacturer for any further requirements.
Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_
Use the selection criteria given for non-ABB motors.
Additional requirements for ABB high-output and IP23 motors
The rated output power of high output motors is higher than what is stated for the
particular frame size in EN 50347 (2001).
This table shows the requirements for protecting the motor insulation and bearings in
drive systems for ABB random-wound motor series (for example, M3AA, M3AP and
M3BP).
Guidelines for planning the electrical installation 83