ABB ACH580-01 VxR R1 Instructions Manual Download

Page: 7 / 7

REPLACEMENT INSTRUCTIONS

ACH580-01 VXR UL TYPE 1 , R1/R2

Step

Instruction

Diagram

Reconnect the RS485 terminal block

to EFB on control unit and

secure with zip tie.

Reconnect any control wiring removed in steps 4 and 5.

WARNING! This configuration does not support Safe Torque Off (STO)
functionality in bypass mode.

Place the top of the drive cover on first, then press down on the
bottom.

Place enclosure cover in place and secure using two (2) M4x16 screws
that were removed earlier.

Using a T20 bit, torque to 14 in-lb (1.5 Nm).

Power and reprogram the drive.

Test and verify drive operation and motor direction.

Back-up and save parameters to the keypad prior to putting the drive
back into service.

Summary of Contents for ACH580-01 VxR R1

Page 2: ...r to disconnecting power Turn off source power and wait 5 minutes for the DC bus capacitors to discharge Turn handle to the off position 2 Using a T20 bit loosen and remove two 2 M4x16 screws securing the enclosure cover Save hardware 3 Remove drive cover by pushing up on the sides as indicated by arrow Recycle drive cover ...

Page 4: ...ive four 4 turns of the screw NOTE Do not remove the screw completely Only loosen enough to be able to lift the drive off the screws 8 Using a T30 bit loosen and remove the top two 2 M6 screws securing the drive Carefully lift the drive out of channel 9 Unpack the replacement drive Remove drive cover by pushing up on the sides as indicated by arrow ...

Page 5: ...x8 screws Remove conduit assembly Recycle the conduit assembly and hardware 11 CAUTION Use two people to install the drive Slide the drive mounting holes over the bottom two 2 screws and slide drive in place Using a T30 bit replace the two 2 M6 screws that were removed earlier Torque all four 4 mounting screws to 27 in lb 3 Nm ...