A binary input channel can be connected to one or several function block inputs,
see
. If a binary input channel is connected to several different function
blocks in ACT, the connection will appear as glue logic in SMT.
A binary output channel can only be activated from one function block output. If it
should be activated from more than one function block output, glue logic has to be
used. Glue logic means inserting a logical gate (OR and AND blocks) between the
function blocks and the binary output channel. This can be engineered in SMT.
Connections made in SMT are automatically shown in ACT.
Connections made in ACT are automatically shown in SMT.
It is possible to group and collapse hardware channels in SMT to
get a better overview.
IEC08000150-2-en.vsd
IEC08000150 V2 EN
Figure 41:
SMT Connection between binary input channels to binary input
signals
Depending on the IED capability, SMT has a separate sheet for each possible
combination.
The possible sheets are:
1MRK 511 261-UEN -
Section 5
Protection and control engineering
650 series
61
Engineering Manual