ABB 2RCA035147, Operating Manual

Page: 10 / 24

10
—
6. Operating the cutting tool on a horizontal
edge (up/down)
To set the cutting head for horizontal guiding: turn the
cutting head to the “HORIZONTAL UP” position so that
“HORIZONTAL UP” marking is visible at the top.
Use the “HORIZONTAL UP” position with cuttings (1-5)
as shown in the section 2.
The cutting tool cuts horizontally from the top and
the bottom at the same time.
Ensure that the cutting head is set in the correct
position, facing “HORIZONTAL UP” at the top.
To cut horizontally, swing the cutting head and place
the cutting head guiding against the bottom and the
left side of the opening.
Place the cutting head exactly on the cut-out
edge so that it is resting against the bottom.