QUICK START GUIDE
Page 8
Version 1.0
© 2021 ABB. All rights reserved.
Step 5
-
Connect DC Output to Ground
DC output is isolated from ground (floating). It must be connected to
•
Connect Ground to an output at a single point.
This connection may be made on the output terminal block .
Note: Either DC Output polarity (Out+ or OUT
-
) must be externally connected to DC Reference Ground (CO
Ground).
Step 6
-
Connect Alarm Cable
•
Remove alarm connector from the chassis.
•
Connect alarm wires.
1.
Strip wire
3/16”
2.
Insert wire fully into wire entry
3.
Tighten screw
4.
Pull wire to verify.
•
Insert alarm connector into the chassis.
Warning: Shock Hazard and Equipment Damage
-
Equipment and subassembly ports
1.
are suitable for connection to intra
-
building or unexposed wiring or cabling;
2.
can be connected to shielded intra
-
building cabling grounded at both ends.
Figure 5: Alarm Connections
