ABB 264B, Operating Instruction

Page: 19 / 56

- 19 -
. . . ADDENDUM FOR "METERS" OPTION OF THE TRANSMITTERS
Zero key and Span key
for three secs.
Zero key and Span key
for only one sec.
VALID
INVALID
Zero key
Span key
Enter MAIN MENU and
ENTER KEY
ESC key
Message for OK action
Message for action
rejected
NEXT key
LAST key
The available options are:
REVIEW:
allows the examination of data and parameters
DspConf: allows the selection of parameter to be displayed and the scale definition
DevConf: allows the transmitter configuration
SEE_VAR: allows the display of primary and secondary variables
SIMUL: allows the simulation of the analog output and the output trimming
For the change of the numeric values, the position is initially given by the flashing of the digit that can be increased or decreased
by the NEXT and PREV key.
Next is the decimal point that can be selected or removed with the NEXT and PREV key.
The ENTER key is used to shift to the next digit, and the ESC key is used to shift to the prev digit.
For the change of the units or another parameter single use the NEXT and PREV key.
Refer to the following diagrams for operations.
General notes:
To enter the main menu the two local keys must be pressed together, and for at least two/three seconds.
The two keys can be then used in the same way (pressed for more than two seconds) to obtain an ENTER key.
For the ESCAPE key they must be pressed together for only one second.
The use of a single key corresponds to the NEXT and PREV keys and more precisely, the ZERO key for NEXT and SPAN key
for PREV. The correct execution causes a VALID message to be displayed, otherwise the message is INVALID.
The following table summarize the main action and message.
MAIN MENU
7.556
KPa
ENTER
REVIEW
ESC
ENTER
DispCnf
NEXT PREV
ENTER
DevConf
NEXT PREV
ENTER
SIMUL
NEXT PREV
ESC
ESC
ESC
SEE-VAR
ENTER
ESC
NEXT PREV
NEXT PREV
ENTER