6
The Slix Stretcher is stored and transported in a Carry Bag.
Remove the Slix Stretcher from the Carry Bag, undo the securing strap and unroll. It is
recommended that the Slix Spinal Splint is used even if no spinal injuries are present or
suspected.
Refer to Page 5 for identification.
1)
Lay on a flat surface, with the Carry Handles down, as close to the casualty as possible. The head
of the Stretcher should be level with the head of the casualty.
Place the Slix Spinal Splint on the Slix Stretcher and attach it to the Spinal Splint Plate with the
two fitted straps provided Item 100SSA p5. Place the casualty on the Stretcher with the head
located to the top of the Spinal Splint and centrally positioned.
OR
If the casualty was loaded onto the Spinal Splint away from the Stretcher, move the casualty
carefully into the Stretcher and attach the Spinal Splint to the Stretcher
2)
Fit the Foot Loops, Item 100FL p5, to the casualties feet, (do not remove footwear), crossing them
over, and adjust buckles. If leg injuries are present it may be necessary to omit one or both Foot
Loops
3)
Starting at the foot secure the 4 Closure Straps, Item 100MCS p5, across the Stretcher and
tighten securely but be careful not to over tighten. Pay particular attention to the Closure Straps at
the chest so respiration is not impaired.
Secure the ends of the Closure Straps so they do not present a snag hazard. Tucking ends in is
easiest
It is recommended that the casualties’ arms are inside the Stretcher skin, as shown on p7
5)
Repeat for the Foot Closure Straps, Item 100FCS p5, and adjust until the rollover just touches the
casualties’ feet. Allowance should be made if a leg splint is fitted.
The casualty is now secure and evacuation may begin.
Loading and Securing a casualty into the
Slix100 Stretcher
