14
Inspection and Cleaning of
The Slix 100 Stretcher
After each use or practice session the Slix 100 stretcher should be cleaned and inspected for damage by a
competent person.
It is very important the stretcher and ancillary equipment is stored ready for use in a first class condition.
IF ANY CLOSURE OR LIFTING STRAPS HAVE BEEN IN CONTACT WITH ANY CHEMICAL, SOLVENT,
ALKALINE, ACID OR ANY CONTAMINANT WHICH MAY DEGRADE POLYETHYLENE, POLYESTER OR
NYLON THE STRETCHER AND/OR LIFTING STRAPS MUST NOT BE USED UNDER ANY
CIRCUMSTANCES.
IF THE STRETCHER HAS BEEN SUBJECT TO A HEAVY DROP ONTO THE VERTICAL OR
HORIZONTAL HAULING POINTS DURING A PRACTICE OR A INCIDENT THE STRETCHER MUST BE
INSPECTED, BY A COMPETENT PERSON IMMEDIATELY AND BEFORE FURTHER USE.
Refer to Page 5 part identification.
Oil, grease, blood, body fluids or non aggressive contaminants may be removed with warm- not hot- water
and soap.
If a power washer is available it may be used with care. After cleaning rinse thoroughly with clean water,
hang vertically and allow to dry in a warm, dry atmosphere.
DO NOT APPLY HEAT.
Inspect Horizontal and Vertical Lifting Slings for physical or chemical damage. The integrity of the Lifting
Straps is essential and particular attention should be given to the stitching and the loop section of the
Slings for wear, If any damage is present DO NOT USE. Replace damaged Lifting Slings immediately.
Inspect all Closure Straps, Closure Buckles, Head & Foot Closure Straps, Carry Handles, Adjustable Foot
Loops and Buckles and Head & Side Grab Handles for physical or chemical damage. Damaged Straps
may be replaced. Contact the manufacture for replacements. DO NOT USE THE STRETCHER before
changing damaged Straps.
Pay particular attention to the Buckles securing the Head & Side Grab Handles. Make sure that the
Buckles are secured correctly with the end of the tape passed back through the Buckle.
Inspect the Vertical Hauling Plate/Spinal Splint attachment point, for damage and/or distortion. Inspect the
area of stretcher around the Vertical Hauling Plate and the Horizontal Hauling Points. If any distortion or
splitting is found DO NOT USE. RETURN TO THE MANUFACTURER FOR FULL INSPECTION.
IF IN ANY DOUBT ABOUT THE INTEGRITY OF THE SLlX100 STRETCHER PLEASE CONTACT THE
MANUFACTURER.
