abaco systems V7768, Hardware Reference Manual

Page: 21 / 92

Publication No: 500-9300007768-000 Rev. H.0 Installation and Setup 21
1 • Installation and Setup
This chapter describes the hardware jumper settings, connector descriptions,
installation, system setup and operation of the V7768/V7769.
1.1 Unpacking Procedures
Any precautions found in the shipping container should be observed. All items
should be carefully unpacked and thoroughly inspected for damage that might
have occurred during shipment. The board(s) should be checked for broken
components, damaged printed circuit board(s), heat damage and other visible
contamination. All claims arising from shipping damage should be filed with the
carrier and a complete report sent to Abaco Systems Customer Care along with a
request for advice concerning the disposition of the damaged item(s).
CAUTION
Some of the components assembled on Abaco products may be
sensitive to electrostatic discharge and damage may occur on boards
that are subjected to a high energy electrostatic field. When the board is
placed on a bench for configuring, etc., it is suggested that conductive
material be inserted under the board to provide a conductive shunt.
Unused boards should be stored in the same protective boxes in which
they were shipped.
1.2 Hardware Setup
The V7768/V7769 are factory populated with user-specified options as part of the
V7768/V7769 ordering information. Contact Sales for ordering information. For
option upgrades or for any type of repairs, contact customer care to receive a
Return Material Authorization (RMA).
Visit our website at:
LINK
www.abaco.com.
The V7768/V7769 are tested for system operation and shipped with factory-
installed header jumpers. The physical locations of the headers and connectors for
the SBC with the PMC option are illustrated in
Figure 1-1 . The definitions of the
connectors, headers and switches are included in Table 1-1 on page 23.
CAUTION
All jumpers marked User Configured in the following tables may be
changed or modified by the user. All jumpers marked Factory Configured
should not be modified by the user.


Care must be taken when making jumper modifications to ensure
against improper settings or connections. Improper settings may result
in damage to the unit.


Modifying any jumper not marked User Configured will void the Warranty
and may damage the unit.