NOTICE
Never run engine without supplying water to the exhaust
system when boat is out of water.
Run the engine about 20 seconds at a fast idle between
4000-5000 rpm.
NOTICE
Never run the engine out of the water longer than 2 minutes.
Drive line seal has no cooling when boat is out of water.
Ensure water flows out of jet pump while flushing. Otherwi-
se, refer to an authorized ABJET Service Center for servicing.
NOTICE
Remove quick connect adapter after flushing operation (if used).
Close the water tap, then stop the engine.
For further information, please refer to the BRP’s Operators
Manual included in the Owner’s package.
28
USE & PERFORMANCE OF YOUR ABJE T TENDER
AFTER USE / TOWING YOUR INFLATABLE
NOTICE
Special precautions MUST be taken when towing a BRP
Rotax powered boat in the water to prevent the exhaust
system and engine from filling with water.
NOTICE
You should only tow your tender for short distances at a
recommended speed.
There are a few different ways to tow your inflatable boat. The
following descriptions are AB recommendations. All RIBs
should be towed by the bow eye (U-bolt). The performance
of the boat will vary depending on the speed, sea conditions,
wind and the distance between boats. Leave at least two (2)
boat lengths between the boats for adequate movement.
The exact distance depends upon the vessel being towed
and should be determined by experience. Adjust the length
of the bow line to match the wave action. Attach a second
line to the towed boat’s bow eye (U-bolt) and tie it separately
to the main vessel. This provides additional safety if main line
Maximum recommended towing speed is 24 km/h (15MPH).
WARNING
The shut off valve MUST be closed for this procedure;
otherwise water can get into the engine sleeve and to
generate a catastrophic damage. Failure to do so, will damage
Towing your inflatable
Summary of Contents for ABJET
Page 1: ...Owner s manual ...
