3
Software Setup
Now the STW-602C hardware is installed and power is on, network IP configuration will be set in this
section.
2.5. Default Settings
The STW-602C has two IP addresses one for Ethernet interface and another one for wireless
network interface. These default settings are shown from under information
Default IP addresses
Interface
Device IP
Subnet mask
Gateway IP
LAN port
10.0.0.50.100
255.255.0.0
10.0.0.254
WLAN Port
192.168.1.1
255.255.255.0
192.168.1.254
The other default settings of STW-602C are shown in the following table
Property
Default Value
Ethernet Port
IP Address
10.0.50.100
Gateway
10.0.0.254
Subnet Mask
255.255.0.0
WLAN Port
IP Address
192.168.1.100
Gateway
192.168.1.254
Subnet Mask
255.255.255.0
Security
User Name
Admin
Password
Null (Leave it blank)
Serial
COM
9600/None/ 8/1,No flow control, packet delimiter disabled
Link Mode
TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled
SNMP
SysName of SNMP
Name
SysLocation of SNMP
Location
SysContact of SNMP
Contact
Table 1. Default settings of the STW-602C device
NOTE: Press reset button for 5 seconds then release the button to restart STW-602C to the default
settings.
Waring: Please avoid setting LAN and WLAN IP address in the same subnet, that may make
unexpect networking problem.
2.6. IP Assignment