
8
detector sounds low , medium, high tones re
specti
vely. A
ft
er
about 2 seconds the detector enters into stand-by state. At
this
time
the default mode is DISC. LCD displays DISC of 00
and SENS of 6 bars.
2. TESTING AND USING THE DETECTOR
To learn how the detector reacts to di
ff
erent metals, you
should test it before you use it the
fi
rst
ti
me. You can test the
detector indoors and
outdoors.
INDOOR TESTING AND USE
1.
Rotate the VOLUME switch clockwise away from OFF to
power on the detector.
2.
Se
tti
ng the opera
ting
mode:
(1) DISC: Press DISC, then + or – to set the DISC numeric
value. If the DISC value is set to 00, the detector can
detect all metals. If you want to
fi
nd one of the target
material listed on the LCD, you can set the rela
ti
ve
numeric range of DISC by pressing DISC then + or -. For
example, the numeric range for 5¢ is 6-17, you can
simply press DISC, then set the DISC number to 7 or 10
by pr or -. If the detector
finds
a coin of 5¢, the
cursor above 5¢ will light.
Note:
1. It is recommended to select the lower or medium
value of the numeric range. Because if you select a
top value, you might miss the target below the
selected value.
2. If you don’t press the bu
tt
ons (DISC,+,-) within
about 2 seconds, the detector will enter the
standby state.
(2) NOTCH: Press NOTCH, then + or – to select the target to