12
Connecting To Power Supply
WARNING:
Make sure the
trigger switch is released before
connecting or disconnecting the power
source. Refer to the “Starting and
Stopping “section.
1. The cable section must be at least
1.5mm
2
and the cable must have a
maximum length of 25m(82ft) and it
must be completely unrolled before
starting to work with the product .
2. This product is designed with a cord
retainer that prevents the extension
cord from being pulled loose while
using.
3. Form a loop with the end of the
extension cord.
4. Form a loop with the end of the
extension cord.
5. Insert loop portion of extension cord
through opening in the bottom of the
rear handle and place over cord
retainer.
6. Slowly pull loop against cord retainer
until the slack is removed.
7. Plug product into extension cord.
WARNING:
Do not allow
familiarity with this product to make
you careless. Remember that a careless
fraction of a second is sufficient to
inflict serious injury.
N
OTE
:
Failure to remove all excess
cord slack from extension cord retainer
could result in plug loosening from
receptacle.
STARTING AND
STOPPING
WARNING:
Always wear
safety goggles or safety glasses with
side shields that comply with ANSI
Z87.1 when operating power tools.
Failure to do so could result in objects
being thrown into your eyes, resulting
in possible serious injury.
After stopping the product, the blade
will not stop immediately. Wait until it
has stopped before carrying out any
maintenance work on the product or
before transporting the product. The
blades don't stop immediately when
releasing the on/off switch, the blades
stop at least 5 seconds after.
Checking Before Starting
1. Replace parts that are cracked,
chipped, or damaged in any way. Do
not operate the unit with loose,
damaged parts or improperly
adjusted.
2. Before start up, remove the security
blade sheath from the blade.
3. Make sure the guard is well fixed to
the product.
The Pole Hedge Trimmer
NOTE:
To help prevent the motor from
