Aastra OpenCom 100, Mounting And Commissioning User Manual

Page: 89 / 244

Configuration Configuring the OpenCom 100
87
7.2.12 Resetting the System Data
You can restore the factory settings of the OpenCom 100 in the Configurator. If this
is not possible, refer to the next section entitled
Basic Hardware Settings Switch .
Please note: If this is done, all individual settings and the user data are
then lost. For this reason, you should back up your configura-
tion regularly, the best time to do so being after every
change. For details, refer to the chapter entitled
Saving and
Loading the Configuration starting on page 81 and to the
Web console online help.
Proceed as follows:
1. In the Configurator, call up the System : Restart menu.
2. Click on Restart with Defaults .
3. Confirm this by pressing “OK” when the query dialogue box opens.
7.2.13 Basic Hardware Settings Switch
The OpenCom 100 configuration can also be returned to the factory settings by
means of the basic hardware settings switch.
Please note: If the factory settings are restored, all customer settings and
user data will be lost.
To restore the OpenCom 100 basic settings, proceed as follows:
1. Switch off the OpenCom 100 by disconnecting the power plug and the plug-in
power supply of the basic module (OpenCom 130).
2. Remove the cover.
CAUTION! Static charges can damage electronic devices.
Observe the regulations regarding electro-
statically sensitive components.