AAQ AutoLift AL-3000BG, Installation Manual & Operation Instructions, Page: 11 / 29

11
manual before operation.
2. Always lift the vehicle at the manufacturer
recommended points.
3. Position the vehicle right on the center of two platforms.
4. Raise the lift by pressing the push button on
control box until the pads touch firmly the
right points and recheck if the vehicle is
secure.
5. Check the security of vehicle, then perform maintenance or
repair work.
6. Press safety lock to make safety teeth engaged, then work under the vehicle.
LOWERING THE LIFT
1. Press down button to lower the lift.
2. The control unit will give alarming when the lift lowered to about 800mm to ground.
3. Press button DOWN II to continue lowering, until reaching complete bottom.
MAINTENANCE
FRIEND will give the user one-year warranty of quality for the machine. If something wrong with the machine within
the term of service, we will repair or replace the product according to the user’s demand. The manufacturer will not
take any responsibility for improper installation and operation, overload running, wrong concrete ground (that can
not meet the requirements in the manual), normal mechanical abrasion and insufficient maintenance. The warranty
will be carried out on the basis of the type and serial number of the equipment. Therefore, the users shall provide
them to the manufacturer without fail.
The several pieces of maintenance operations to be carried out are described below. A low operating cost and a
long life of the machine are from routine observation of there operations.
The listed intervention times are given for information and they refer to normal operating conditions. They can
change according to the kind of service, environment, frequency of use, etc.
1.
DAILY PRE-OPERATION CHECK
The user should perform daily check. Daily check of safety latch system is very important – the discovery of
device failure before needed could save you from expensive property damage, lost production time,
serious personal injury, even death.
. Check safety lock audibly and visually while in operation
. Check hydraulic connections, and hoses for leakage.
. Check chain connections, cable connections, wiring and switch for damage.
. Check bolts, nut and screws and tighten.
. Check swing arm restraints.
2. WEEKLY MAINTENANCE
. Check the cleanness of the mobile parts.
. Check the safety device as previously described.