AAQ AutoLift AL-167251, Installation Manual & Operation Instructions, Page: 9 / 31

Press UP button
Motor drives the gear pump work
Cylinder piston drives the chain work
Chain drives the carriage rise
The
hoist
is raised
Start
Start
Press UP button to raise the carriage 5cm
Pull the unlocking steel cable at both sides
The
hoist
is lowered
Press the unloading handle
3.4 Items to be checked after installation.
S/N Check items YES NO
1 Is the post vertical to the floor?
2 Is the oil hose well connected?
3 Is the steel cable well connected?
4 Are all lifting arms well fixed?
5 Are electrical connections right?
6 Are the rest joints firmly screwed?
7 Are all items need lubricating added with grease?
OPERATION INSTRUCTIONS
4.1 Precautions
4.1.1 Check all the joints of oil hose. Only when there is no leakage, the hoist can start work.
4.1.2 The hoist , if its safety device malfunctions, shall not be used.
4.1.3 The machine shall not lift or lower an automobile if its center of gravity is not positioned midway of the lifting arms. Otherwise,
the EverLift as well as our dealers will not bear any responsibility for any consequence resulted thereby.
4.1.4 Operators and other personnel concerned should stand in a safety area during lifting and lowering process.
4.1.5 When lifting arms rise to the desired height, switch off the power at once to prevent any mal-operation done by unconcerned
people.
4.1.6. Make sure the safety lock of the hoist is engaged before start working under the vehicle and no people under the vehicle
during lifting and lowering process.
4.2 Flow chart for operation
Raising Lowering