167212E
Nov. 2016
７
STEP 2
: (Unloading and Unpacking)
1.
After unloading the
hoist
, place it near the
intended
installation location. (See Fig.4)
2.
Remove the shipping bands and packing
materials from the unit.
3.
Remove the packing brackets and bolts holding
the two columns together. (Do not discard bolts,
they may be used in the assembling of the
hoist
)
4.
Take out the lifting arms, pads, accessory box, oil
pipes, etc, from the column. Check the quantity of
every item with the pats list. If any missing, please
contact with your dealer at once.
Fig. 4 (packing)
STEP 3
: (Site Layout)
1.
Determine which side will be the approach side.
2.
Once a location is determined, use a carpenter’s chalk line to layout a grid for the post locations.
Keep all dimensions and square within
1
/
8
“otherwise malfunction of the
hoist
will occur. (See Fig. 3)
3.
After the post locations are properly marked, use a chalk or crayon to make an outline of the posts on
the floor at each location using the post base plates as a template.
4.
Double check all dimensions and make sure that the layout is perfectly square.
STEP 4
: (Installing the Column)
1.
Before proceeding, double check measurements and make certain that the bases of each column
are square and aligned with the chalk line.
2.
Using the base plate on the column as a guide, drill each anchor hole in the concrete with depth
equal to the anchor using a rotary hammer drill and
7
/
8
” concrete drill-bit. To assure full holding power,
do not ream the hole or allow the drill to wobble. (See Fig.1)
3.
After drilling, remove dust thoroughly from each hole using compressed air and/or wire brush. Then
put the recessed anchors in the holes. Make certain that the anchors not above the floor. (See Fig. 5)
4.
Move the columns to the position over the recessed anchors (See Fig. 6). Make sure the bolt holes
line up with the recessed anchors in the concrete. Secure each column to the floor using the five
5/8”*2” high-yield bolts.
Fig. 5
Fig. 6
Summary of Contents for 167212E
Page 6: ...167212E Nov 2016 ６ Fig 3 ...
Page 17: ...167212E Nov 2016 １７ PARTS CODE AND DRAWING Fig 24 column carriage lifting arm cylinder ...
Page 21: ...167212E Nov 2016 ２１ PARTS CODE AND DRAWING Fig 25 control box detail ...
Page 23: ...167212E Nov 2016 ２３ PARTS CODE AND DRAWING Fig 26 motor pump detail ...
