AAP Elite S series, Operating Manual

Page: 19 / 32

19
To change the DTMF Output Control code press;
<PROGRAM> <175> <ENTER> <12> <ENTER> <####> <ENTER>
#### = 1-4 digit code
To change the DTMF Microphone Control code press;
<PROGRAM> <175> <ENTER> <13> <ENTER> <####> <ENTER>
#### = 1-4 digit code
To change the DTMF Voice/Domestic Alarm Acknowledge code press;
<PROGRAM> <175> <ENTER> <14> <ENTER> <####> <ENTER>
#### = 1-4 digit code
To change the DTMF Force Test Call code press;
<PROGRAM> <175> <ENTER> <15> <ENTER> <####> <ENTER>
#### = 1-4 digit code
PROGRAMMING/DELETING or FINDING RADIO KEY CODES or
ACCESS TAGS
The alarm system can have up to 80 radio users programmed. The op-
tional receiver board must be fitted to allow radio users to work. Radio us-
ers can be programmed at User locations 21-100. It can alternatively have
up to 100 access control tags or cards programmed at user locations 1-
100. There must be at least one proximity reader connected to the panel
for access tags/cards to work. The owner can add/remove or find radio
users or access tags from
CLIENT program mode.
To Learn a new Radio User press;
<PROGRAM> <18> <ENTER> <21-100> <ENTER>
21-100 is User number 21-100. When in learn mode the keypad will beep
at one second intervals for 30 seconds. You must operate the radio key
within this period to learn it into the panel.
To Delete an existing Radio User press;
<PROGRAM> <19> <ENTER> <21-100> <ENTER>
21-100 is User number 21-100. You must enter the exact Radio User you
wish to delete.
To Find an Existing Radio User press;
<PROGRAM> <20> <ENTER> <0> <ENTER>
During find mode the keypad will beep at one second intervals for 30 sec-
onds. You must operate the radio key within this period. If the radio User
code is found in memory the User number will be displayed at the keypad.