![background image](http://html1.mh-extra.com/html/aandd/sv-100a/sv-100a_instruction-manual_446156092.webp)
90
AX-SV-36 Positioning Stopper
•
Used to fix the position of the sensor unit and the
sensor plates so that positioning the sensor plates
and the sample surface is not required each time a
measurement is performed in a repetitive test. See
below for how to attach the positioning stopper.
How to attach the positioning stopper:
1 Raise the lever so that the sensor unit
can be moved.
2 While pinching the grips, lift out the
sensor unit from above.
3 While pinching the grips on the
positioning stopper, attach the
stopper, with the lever on the left side
as seen from front, on the supportintg
post. Be sure to place the guide
located on the inner wall of the stopper
in the guide channels located on the
supporting post.
4 Position the stopper at an appropriate
height. Raise the lever to secure the
stopper.
5 While pinching the grips, attach the
sensor unit on the supporting post.
6 Lower the sensor unit until it comes
into contact with the stopper.
7 Lower the lever to secure the sensor
unit.
Supporting post
1
2
7
Lever
Sensor unit
Grips
Positioning stopper
Make these surfaces
come into contact
Sensor plates
6
4
Guide channel
Grips
Sensor unit
Summary of Contents for SV-100A
Page 6: ...4 ...