9
11. Choose the appropriate alignment tools for your job (Gauge Bar Guide, Ribbon Plate, Napkin Guide,
Business Card Guide, Match Guide, or Pencil Guide, etc.) and set up the alignment tools on the table
plate of the machine.
[Pg. #12-15 ]
12. Choose the proper cushion board if necessary.
[Pg. #12]
13. M2000: Begin printing by pulling down the machine handle. Control quality of print by varying
pressure and dwell (duration of print).
[Pg. #20]
AIR2000 & TITAN2000: Begin printing by pressing the foot activation switch. Be sure your hands are
clear and that the product is appropriately lined up under the typehead. Be sure that the typehead and
type/die holders have adequate clearance and will not collide with any of the setup alignment tools such
as the 10x12 base plate. Control the quality of print by varying the pressure and dwell (duration of
print).
[Pg. #20]
ADDITIONAL
TIPS:
In the case of deep leather embossing you can also use a thick piece of foam to gain
a deep impression into your leather products. In this case you will be embossing and can not use foil i
n this
process.
Additional Helpful Items
To Cut excess Foil.
Scissors :
Ruler:
To measure product and for aligning fixtures.
Getting Started
(continued)
14
