S- & D-Type / EN
Seite 4/4
Version-5
Basic cleaning / Service For basic cleaning or repair
(see Service Kit under Spare parts), please refer to
other helpful instructions, which you can find at our
below QR-Codes. Otherwise, the tap (2) can be
disassembled into its individual parts quite easily by
removing the automatic stop, the handle and the side
adjustment lever for the purpose of detailed cleaning.
The same applies to the dispense head (1). Here, as
before, remove the pressure reducer (4) to separate it
together with the gas line and the plug-in coupling (3).
On the dispense head (1), the handle can be removed
by loosening the screw on the side. Now the probe can
be pulled upwards out of the dispense head (1). On the
probe, you can remove the screw plug at the upper
end to access the ball inside. This means that all areas
are fully accessible for basic cleaning and individual
parts such as seals can be replaced if necessary.
Make sure not to damage any sealing surfaces with
improper tools. This would allow gas to escape and lead to malfunctions.
Do not put the dispensing unit in the dishwasher. The seals and plastic parts would be
damaged.
Disposal
:
This can be done in the normal way (e.g. residual waste), as no environmentally harmful
substances have been used.
Spare parts
– visit our WebShop:
www.disptek.shop
P/N DT00132: Gasline incl. pre-assembled nozzle and elbow connector
P/N DT00130: Service Kit S-Type with all seals for dispense head (1) and Tap (2)
P/N DT00131: Service Kit D-Type with all seals for dispense head (1) and Tap (2)
P/N DT00011: Cleaning brush S- and D-Type
P/N DT00115: Grease
WebShop
Manual
Tutorial
This product was tested and certified!
