Aaeon PCM-5892, Manual

Page: 37 / 120

Chapter 2 Installation 27
Display connectors (CN1, CN3)
The mainboard's PCI SVGA interface can drive conventional CRT
displays and is capable of driving a wide range of flat panel
displays, including electroluminescent (EL), gas plasma, passive
LCD, and active LCD displays. The card has two connectors to
support these displays, one for standard CRT VGA monitors and
one for flat panel displays.
VGA display connector (CN1)
CN1 is a 16-pin, dual-in-line header used for conventional CRT
displays. A simple one-to-one adapter can be used to match CN1 to
a standard 15-pin D-SUB connector commonly used for VGA.
VGA display connector (CN1)
Pin Signal Pin Signal
1 RED 9 SIGNAL GND
2 N/C 10 H-SYNC
3 GREEN 11 CHASSIS GND
4 SIGNAL GND 12 V-SYNC
5 BLUE 13 CHASSIS GND
6 N/C 14 N/C
7 N/C 15 CHASSIS GND
8 N/C 16 N/C
When the mainboard's power is applied, the control signal is low
until just after the relevant flat panel signals are present.
Configuration of the VGA interface is done completely via the
software utility. You don't have to set any jumpers.