Aaeon PCM-4330, Instructions Manual

Page: 90 / 127

90
n
8 Beeps: Video adapter error
Replace the video adapter or video adapter display memory RAM.
n
9 Beeps: ROM-checksum error
The BIOS will probably have to be replaced.
n
Io Beeps: CMOS-RAM register error
The board must be replaced
n
11 Beeps: Cache error
Check the cache memory on the board.
On-screen Error Messages
if an error occurs during POST one or more of the following messages may appear
on the display:
ERROR Message Line 1
ERROR Message Line 2
Press <F1> to continue
The program stops, if the setup option Halt On Ewors is set to All ewors.
Alternatively, the program might prompt you to run the setup utility program to
correct settings. The following message would be displayed on-screen:
RUN SETUP UTILITY
The following section describes error messages, provides explanations and suggests
work-arounds. Further POST messages and problem work-arounds can be found in
the reference documents.
8042 Gate-A20 Error
The keyboard controller gate Azo does not work properly. Replace the keyboard
controller.
Address Line Short!
Address coding error.
C: Drive Error
Drive C: does not respond. Use the diagnostic utility program AM~Diag Hard Disk
Utility to test the drive and check that all hard disk drive parameters and hard disk
setup settings are correct.
C: Drive Failure
Drive C: does not respond. Replace the hard disk drive.
Cache Memory bad. Do Not enable Cache!
The cache memory is corrupt. Run the AMIDiag diagnostic utility program.
CH-2 Timer Error
Timer 2 error.
6.1.2