2-17
Chapter 2: Motherboard information
CAUTION:
Do not forget to connect the fan cables to the fan connectors.
Insufficient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
connectors!
3. Chassis / CPU fan connectors (4-pin CHA_FAN1, 4-pin CPU_FAN1)
Connect the fan cables to the fan connectors on the motherboard, ensuring
that the black wire of each cable matches the ground pin of the connector.
EMB-Q170A
EMB-Q170A Fan connectors
CHA_FAN
GND
VCC
SENSE
PWM
CPU_FAN
PWM
SENSE
VCC GND
A
A
B
B
PIN 1
PIN 1
4. Serial ATA 6.0Gb/s connector (7-pin SATA6G_1~2)
ThIS connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
IMPORTANT:
• You must install Windows
®
7 or later version before using Serial ATA hard
disk drives.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section
3.3.3 SATA Configuration
for details.
EMB-Q170A
EMB-Q170A SATA 6.0Gb/s connectors
SATA6G_1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA6G_2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
Summary of Contents for EMB-Q170A
