AAdynTech Punch Series Light, User Manual

Page: 4 / 19

4
•
Make sure that light is only used in dry location. Do not use light in or around falling water, wet
locations or moisture.
•
Always allow adequate ventilation of the light. Never cover or in any way obstruct the louvered
openings in the light.
•
If light is suspended either from above or below using yoke, make sure that a safety cable (not
supplied) is attached to the light and properly secured. The strength of the cable/chain should be
sized suitably to hold 6 times the weight the secured light. Note: Weight of fixture is 50 lbs.
•
When mounting the light, make sure that only hardware rated for the weight and size of the fixture is
used.
•
Never look directly into the light source while the fixture is turned on. Light source is very bright and
could cause damage to eyes.
•
Do not probe or touch any interior features of the fixture. This includes the LED sources inside the
barrel of the light. Doing so may cause damage to the fixture and/or may present a shock or burn
hazard.
•
Always make sure that the light fixture is connected to the proper power source with proper voltage
and current ratings. Also, make sure that adequate over current protection is provided for the circuit
as well.
Introduction
Product Description
The Punch series light is a professional grade, LED based, fixture which provides exceptional light
output and control. The light is capable of standalone, tethered remote, wired DMX, or wireless DMX
control and offers a full array of brightness settings as well as Strobe and Lightning functions.
Features
•
Light Off Control
•
CIM/UIM Control
•
DMX control (Compatible with Slow and Fast speeds)
o
Up to 500 selectable DMX addresses
o
Daisy-chain operation of up to 32 lights in one string
o
Controls Brightness, Fade, Strobe and Lightning modes
Note: This light contains no user serviceable parts. Do not open
the light housing or attempt any repair or modification of the
light. Failure to observe this warning could result in damage
to the light, injury and/or voiding the limited warranty.
Warning! Inserting objects or fingers inside louvered openings
could result in a shock hazard/injury and damage to the
light.