AAdynTech Punch Series Light, User Manual

Page: 14 / 19

14
The software shall retain the menu state after the UIM is unplugged and remain on the same screen if
the UIM is reattached.
1.2. Douse Switch/Douse Button
•
The software shall separately detect and process a press and release of the red Cancel (X) button
from the UIM. On Cancel button press, the software shall turn off the LED’s immediately. On
Cancel button release, the software shall turn on the LED’s immediately if the Douse switch is not
being pressed.
1.3. Wireless DMX Operation- Special User Instructions Enclosed
•
The wireless transmitter/receiver of the Punch light is designed to communicate with City Theatrical
transmitters/ receivers.
•
The back panel of the Punch light has three LED indicator lights (red, yellow, green) that show
wireless signal strength/link.
•
When installing the Punch light, make sure to adjust wireless antenna for best signal reception.
1.4. DMX Controller Interface Requirements
•
The software shall accept input from the DMX512 controller that represents user requested values
for BRIGHTNESS, FADE, EFFECT, EFFECT FREQUENCY and EFFECT ACTIVATION.
•
The DMX input to the light is mapped as follows for each DMX MODE:
•
1 CHANNEL mode: Each DMX channel shall be used for BRIGHTNESS control.
•
2 CHANNELS mode: DMX channel 1 shall be used for BRIGHTNESS control. DMX
channel 2 shall be used for FADE control.
•
5 CHANNELS mode: DMX channel 1 shall be used for BRIGHTNESS control. DMX
channel 2 shall be used for FADE control. DMX channel 3 shall be used for EFFECT
SELECTION control. DMX channel 4 shall be used for EFFECT FREQUENCY control.
DMX channel 5 shall be used for EFFECT ACTIVATION control.
•
When the mode is set for more than one channel, BRIGHTNESS will be at the DMX BASE
ADDRESS, FADE will be at DMX BASE A 1, etc.
•
DMX BRIGHTNESS parameter shall range between 0 and 255. 0 means the light is off and
255 means the light is 100% bright.
•
DMX FADE parameter shall range between 0 and 255. 0 means that fade is completely off
and 255 means that a three to four second fade is present.
•
DMX EFFECT SELECTION parameter shall range between 0 and 255. The selections shall
be as follows:
0: No Effect Selected
1 – 40: Lightning 1 Selected
41 – 80: Lightning 2 Selected
81 – 120: Lightning 3 Selected
121 – 160: Lightning 4 Selected
161 – 200: Lightning 5 Selected
201 – 255: Strobe Selected
•
DMX EFFECT FREQUENCY parameter shall range between 0 and 255. 0 means that the
effect frequency is at a maximum. 255 means that the effect frequency is at the minimum.
•
DMX EFFECT ACTIVATION parameter shall range between 0 and 255. 0 means that he
effect is off. 1 through 255 means that the effect is activated. An effect shall be reactivated
only if channel 5 is brought to 0 and then made positive again.