8
4.3 Installing the handlebar and display
1.
Using a 4 mm allen key,
unscrew the three bolts that
hold the handlebar clamp
to the handlebar stem (pic
a). Remove the cap from
the handlebar stem.
2.
Install the steering stopper.
Ensure the stopper that the
stopper will not touch the stee-
ring tube. Tighten the bolts to
6 Nm (pic b).
3.
Nest the handlebar into the handlebar stem, ensuring that
it is centred and properly oriented. Replace the cap, reinstall
the bolts holding the cap to the stem and tighten securely
the bolts to 6 Nm per bolt (pic c).
It is essential to tighten
all three bolts evenly to
ensure proper installation.
The bolt located on the
top of the stem should be
tightened to no more than
1 Nm. The left side bolt
on the bar stem must be
tightened to 10-12 Nm.
4.
Install the display and
tighten the bolts to 6 Nm
per bolt (pic d).
5.
Install the key lock and
tighten the bolt to 3 Nm (pic
e).
The 'Nm' measurements
refer to the torque value
that should be applied
to the tightening of bolts,
please use an appropriate
spanner to apply the
correct torque values as
specified.
a
b
c
d
e