9
IP address settings
(continued)
Setting new static IP
address in the ECX-200
Connect your PC to each
EXM unit after that you have
done all other settings in the
units and change to a
specific IP address for every
unit.
A recommendation is to use
from 192.168.0.21 and
higher.
NOTE!
Almost every switch/router
use 192.168.0.1 as default IP
address so make sure you don’t
use the same IP address in any
ECX-200 unit.
To continue installation press
[Input]
4.3.3 Input settings
Select Baudrate, Constellation
and the channel number
according to CCIR or enter
the correct frequency (in
MHz). Press [Set] to enter the
frequency to the ECX-200.
A list of the available services
from the multiplex you tuned
to, will be shown on the right
hand side and also available
services via the ASI input.
Below [Tuner settings]
information of the received
signal is displayed.
4. Settings (continued)
English
