In case of button lock-out, errors or freeze of the display it is recommended to re-set
your remote control.
Your lovely picture can be saved and displayed.
Send your own image (jpg format) and the remote
to near dealer.
Powered by a built-in 3.7V Lithium Polymer battery.
If the battery level shows one bar, charge your remote.
The LED of the charger lights GREEN when the battery is full
(after ca. 15 ̄30 min.). Refrain from unnecessary pressing of the
buttons to prevent rapid current consumption.
Plug-in Car Charger
5
Attach the touch sensor on the front windshield. You can lock and
unlock the doors without a key or remote by fingering of the saved
4-digit PIN on the touch sensor.
☞ See page 15 how to use.
The LED in the middle indicates current status of the system.
6
Communication Module & Touch Sensor
Attach the antenna (so-called Transceiver) on the front windshield or frame.
When attached on the place where the window is tinted, the operating range can be
apparently shortened due to RF interception.
■
LED Indicator
R/B flash continuously: system armed
Red flashes: the vehicle is attacked
Blue On: valet mode
Blue flashes: auto-arming
LED Off: system disarmed
We recommended to remove stuff (like snow and mud) and to dry the part
around the sensor on the front windshield.
Don't use the touch sensor with the gloved finger.
■
Adjustment of the Proximity
Adjust the sensitivity of the proximity (key-
less entry) by turning of the screw in the
middle. Turn it clockwise to diminish, and
counter-clockwise to increase the distance.
Touch Sensor
Communication Module
Reset
Remote Control
Image Box (Optional)
Charging the Battery
✔
To reset prick a pin into the small hole in the middle of the left side.
✔
To view the image (2 sec. long) press button II.
TOUCH
Use the supplied plug-in car charger ONLY. Otherwise, the
battery could explode or the remote's circuit can go wrong.
Plug in the charger when the engine is running.